Lenovo NetVista Hardware Maintenance Manual for NetVista 6018, 6058, 6059, 626 - Page 22
Make sure the component that is called out is, Run Setup, enable port
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Diagnostic Error Code FRU/Action 011-013-XXX 011-014-XXXSerial port Control Signal/Loopback test failure 1. System board 011-015-XXXSerial port External Loopback failure 1. Wrap plug 2. System board 011-027-XXXSerial port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system 3. System board 011-03X-XXX 011-04X-XXXSerial port failure 1. System board 011-195-XXXSerial port Test aborted by user 1. Information 2. Re-start the test, if necessary 011-196-XXXSerial port test halt, error threshold exceeded 1. Press F3 to review the log file 2. Re-start the test to reset the log file 011-197-XXXSerial port test warning 1. Make sure the component that is called out is connected and/or enabled 2. Re-run test 3. Component that is called out in warning statement 4. Component under test 011-198-XXXSerial port test aborted 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test 3. Go to the ″Undetermined problems″ section 011-199-XXXSerial port test failed, cause unknown 1. Go to the ″Undetermined problems″ section 2. Flash the system and re-test 3. Replace component under function test 011-2XX-XXXSerial port signal failure 1. External serial device 2. System board 014-000-XXXParallel port Interface Test Passed 1. No action 014-001-XXXParallel port Presence 1. Remove external parallel device, if present 2. Run setup, enable port 3. System board 014-002-XXX 1. System board 014-003-XXXParallel port Timeout/Parity error 8 Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648, 6649