Lenovo NetVista Hardware Maintenance Manual for NetVista 6018, 6058, 6059, 626 - Page 23
Remove USB devices and re-test
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Diagnostic Error Code FRU/Action 014-013-XXX 014-014-XXXParallel port Control Signal/Loopback test failure 1. System board 014-015-XXXParallel port External Loopback failure 1. Wrap plug 2. System board 014-027-XXXParallel port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system 3. System board 014-03X-XXX 014-04X-XXXParallel port failure 1. System board 014-195-XXXParallel port Test aborted by user 1. Information 2. Re-start the test, if necessary 014-196-XXXParallel port test halt, error threshold exceeded 1. Press F3 to review the log file 2. Re-start the test to reset the log file 014-197-XXXParallel port test warning 1. Make sure the component that is called out is connected and/or enabled 2. Re-run test 3. Component that is called out in warning statement 4. Component under test 014-198-XXXParallel port test aborted 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test 3. Go to the ″Undetermined problems″ section 014-199-XXXParallel port test failed, cause unknown 1. Go to the ″Undetermined problems″ section 2. Flash the system and re-test 3. Replace component under function test 014-2XX-XXX 014-3XX-XXXParallel port failure 1. External parallel device 2. System board 015-000-XXXUSB port Interface Test Passed 1. No action 015-001-XXXUSB port Presence 1. Remove USB device(s) and re-test 2. System board 015-002-XXXUSB port Timeout 1. Remove USB device(s) and re-test 2. System board Chapter 1. IBM PC Enhanced Diagnostics error codes 9