Lenovo NetVista Hardware Maintenance Manual for NetVista 6018, 6058, 6059, 626 - Page 77
Internal drive removal
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Internal drive removal Note: The internal drive assembly is designed to latch firmly into place. When pivoting the drive cage out, you will feel some initial resistance, so you should pull firmly until the drive cage swings out. Inversely, when you swing the cage back into the machine case, you should feel a slight resistance until the cage snaps solidly back into place. 1. Pivot the drive bay cage up and toward the front of the computer. 2. Latch the handle to the front of the chassis, so that the drive cage stays upright. 3.5″ drive removal 1. Remove the two screws from the right side of the drive. Lift the drive out. Note: Be sure to place the 3.5″ drive cable under the single tab on the bottom of the drive cage. Press the cable down so that the cable folds underneath the drive cage, toward the front of the chassis, instead of folding back toward the system board. This will ensure the 3.5″ drive cable is not pinched when the drive cage is firmly placed into its horizontal operating position. Chapter 2. Types 6568/6569/6648/6649 63