Lenovo ThinkServer RD240 Hardware Maintenance Manual - Page 35
Solving Ethernet controller problems, Solving undetermined problems
View all Lenovo ThinkServer RD240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
If the server does not start from the minimum configuration, replace the components in the minimum configuration one at a time until the problem is isolated. Solving Ethernet controller problems The method that you use to test the Ethernet controller depends on which operating system you are using. See the operating-system documentation for information about Ethernet controllers, and see the Ethernet controller device-driver readme file. Try the following procedures: • Make sure that the correct device drivers, which come with the server, are installed and that they are at the latest level. • Make sure that the Ethernet cable is installed correctly. - The cable must be securely attached at all connections. If the cable is attached but the problem remains, try a different cable. - If the Ethernet controller is set to operate at 100 Mbps, you must use Category 5 cabling. - If you directly connect two servers (without a hub), or if you are not using a hub with X ports, use a crossover cable. To determine whether a hub has an X port, check the port label. If the label contains an X, the hub has an X port. • Determine whether the hub supports auto-negotiation. If it does not, try configuring the integrated Ethernet controller manually to match the speed and duplex mode of the hub. • Check the Ethernet controller LEDs on the rear panel of the server. These LEDs indicate whether there is a problem with the connector, cable, or hub. - The Ethernet link status LED is lit when the Ethernet controller receives a link pulse from the hub. If the LED is off, there might be a defective connector or cable or a problem with the hub. - The Ethernet transmit/receive activity LED is lit when the Ethernet controller sends or receives data over the Ethernet network. If the Ethernet transmit/receive activity LED is off, make sure that the hub and network are operating and that the correct device drivers are installed. • Check the LAN activity LEDs on the rear of the server. The LAN activity LED is lit when data is active on the Ethernet network. If the LAN activity LED is off, make sure that the hub and network are operating and that the correct device drivers are installed. • Check for operating-system-specific causes of the problem. • Make sure that the device drivers on the client and server are using the same protocol. If the Ethernet controller still cannot connect to the network but the hardware appears to be working, the network administrator must investigate other possible causes of the error. Solving undetermined problems If the diagnostic tests did not diagnose the failure or if the server is inoperative, use the information in this section. If you suspect that a software problem is causing failures (continuous or intermittent), see "Software problems" on page 21. Damaged data in CMOS memory or damaged firmware can cause undetermined problems. To reset the CMOS data, use the password switch 2 (SW4) to override the power-on password and clear the CMOS memory; see "Locating parts on the system board" on page 30. Check the LEDs on all the power supplies. If the LEDs indicate that the power supplies are working correctly, do the following: 1. Turn off the server. 2. Make sure that the server is cabled correctly. Chapter 5. Diagnostics 23