Lenovo ThinkServer RD240 Hardware Maintenance Manual - Page 83
with the battery card assembly accessory kit.
View all Lenovo ThinkServer RD240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
c. Hold the battery card assembly with the battery side up and the J1 board-to-board connector lining up with the J6B1 BBU connector 1 on the RAID controller. Carefully press the battery card assembly onto the RAID controller so that the two connectors are firmly joined. Then, secure the battery card assembly to the RAID controller with the three screws and the standoffs that come with the battery card assembly accessory kit. Figure 47. Installing the battery card assembly onto the RAID controller 1 J6B1 BBU connector 6. Connect the mini SAS signal cables to the RAID controller. Note: Use the 400 mm (15.75 inches) mini SAS signal cables. Figure 48. Connecting the mini SAS signal cables to the RAID controller 1 Ports 0-3 2 Ports 4-7 a. For one mini SAS signal cable, connect the end to the ports 0-3 on the RAID controller. b. For the other mini SAS signal cable, connect the end to the ports 4-7 on the RAID controller. Chapter 7. Installing, removing, or replacing hardware 71