Lexmark X7500 Service Manual - Page 60
Adjusting the Position of Full Rate/Half Rate Carriages
UPC - 734646391306
View all Lexmark X7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
4036-501 Adjusting the Position of Full Rate/Half Rate Carriages 1. Remove the flatbed center platen glass plate. 2. Loosen the two (2) screws that secure the full rate carriage. 3. Move the half rate carriage until it rests against the stopper. Note: When the half rate carriage rests against the paper stop (2 pieces), a gap may be generated on either the In or Out side stopper. Before you move to the next step, loosen the two (2) screws on the rear pulley-capstan, and again tighten the screws with the carriage pushed against the paper stop on either the In or Out side. 4. While the half rate carriage rests against the steppers, move the full rate carriage until it rests against the right side frame. 5. Tighten the two (2) screws in the full rate carriage. 6. Mount the flatbed center platen glass plate. 4-6 Service Manual