LiftMaster 61LM Owners Manual - Page 134

OWNERS MANUAL Model 100 (with 1 transmitter) and Model 100-2 (with 2 transmitters) Lift-Master Universal Radio Control Manufactured under 1 or more of the following US patents 3,445,848; 3,906,348; and 4,037,201 THIS RADIO CONTROL WILL NOT WORK WITH 'PUSH TWICE TO CLOSE' DOOR OPENERS. The Model 85 Transformer may be required if your garage door opener is a brand OTHER THAN Lift-Master, Chamberlain or Sears. RADIO CONTROLS consist of a transmitter and a receiver. The transmitter sends a coded signal from outside the garage. The receiver, installed inside the garage, accepts the transmitted signal and starts the door opener. When installing two or more receivers in a garage, position them at least 10 feet apart to prevent electronic interference. Self sevice of radio controls is not recommended. If service is needed, follow instructions on Page 2. INSTALL THE RECIEVER OUT OF THE REACH OF CHLDREN. DO NOT ALLOW CHILDREN TO OPERATE RECEIVER OR TRANSMITTER. SERIOUS PERSONAL INJURY FROM A CLOSING GARAGE DOOR MAY RESULT FROM MISUSE OF THE OPENER. DISCONNECT POWER TO OPENER BEFORE INSTALLATION RECEIVER OR SETTING/CHANGING CODE. The receiver may be installed in one if two ways: 1: attached to an inside wall of the garage with connecting bell wire (not supplied) 2. mounted directly directly on the door opener with clips provided. NOTE: Receiver and transmitter are factory pre-set with matching codes. Caution: DO not attempt to open receiver back panel. NO USER SERVICEABLE PARTS MOUNTING RECEIVER ON OPENER Make sure antenna wire is fully extended downward below bottom of case. Loosen the three receiver terminal screws labeled 1, 2 and 3. Insert one end of each mounting clip under a terminal. Make sure the clip is positioned to clear receiver flange as shown. Do not retighten at this time. Loosen the (2) push button terminal screws on the opener as well as the adjacent terminal screw which supplies the power. (These terminals should also be marked 1,2 and 3). NOTE: Terminals 1, 2 and 3 on the receiver MUST be connected to terminals 1, 2 and 3 on opener. Leaving push button wiring in place, insert other ends of mounting clips under opener screws. If the terminal sequence on your opener does not match, turn the receiver around (so back is facing out) and complete connection. Retighten terminal screws on opener and receiver. Reconnect power to the opener. The receiver push button should light. If it does not, use Transformer Model 85. NOTE: With Transformer Model 85, use a 2-terminal connection ONLY. Attach clips to receiver terminals 1 and 2, and to opener terminals used for push button controls. If using Transformer Model 85, plug the transformer into a 120 Volt outlet. MOUNTING RECEIVER ON GARAGE WALL The receiver has top and bottom installation flanges. Make sure antenna wire is fully extended downward below the bottom of the case. Fasten receiver to an inside garage wall with wood screws provided. A convenient place is alongside service door and OUT OF REACH OF CHILDREN. Connect one end of 3-strand bell wire to receiver terminals 1, 2 and 3. The other end must be connected to the two opener terminals used for push button controls and the adjacent terminal which supplies the power. Use insulated staples to secure bell wire between receiver and opener. Reconnect power to the opener. The receiver push button should light. If it does not, use Transformer Model 85. NOTE: With transformer Model 85, use a 2-wire connection ONLY. Attach bell wire to receiver terminals 1 and 2, and to opener terminals used for push button controls. If using Transformer Model 85, plug the transformer into terminal 1.