LiftMaster 61LM Owners Manual - Page 165
Model 82LM Two-Function Remote Control, OWNERS' MANUAL
View all LiftMaster 61LM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Model 82LM Two-Function Remote Control OWNERS' MANUAL The push buttons on the Two-Function remote controls can activate garage door openers, entry ways and/or light controls.(Instructions for programming light products are included with those accessories.) Code switch remote controls are used when several persons are operating the same device. Code switches must be set to matching positions in all remote controls used to operate the same receiver. Use the "smooth" push button, exclusively for code switch application. Follow the instructions described and shown below. Figure 1 Green Test Light Recommended for code switch applications WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. To Erase All Codes From Motor Unit Memory For use with green "learn" button ONLY Program smooth push button (Code switch application) 1. Slide back the battery compartment cover on the bottom of the remote control housing 2. Place the old and new remote controls side by side. Make sure you set code switches 1 through 9 in all remotes to matching positions (Figure 2). Use a pen or screwdriver to move the switches to (+), (-) or (0). 3. Replace the battery compartment cover. To deactivate any unwanted remote, first erase all codes: Press and hold the "learn" button on motor unit until 1 the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use. The Remote Control Battery WARNING To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. 2 3 KG KG + 0 + 0 123456789 123456789 Figure 2 Match code switches (1-9) Program ribbed push button (Green "learn" button) The 12V battery should produce power for at least a year. If the green test light is dim or does not come on, replace the battery. To change the battery, slide back the battery compartment cover. Position the new battery as indicated. Replace the battery compartment cover. 1 2 3 9 1 7 3 5 9 1 7 3 5 1 2 NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1. Press and release the "learn" button on the motor 1 unit. The learn indicator light will glow steadily for 30 seconds. 2. Within 30 seconds, press and hold the button on the hand-held remote. 3. Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard. 2 3 KG KG Replacement Parts Remote case only (circuit board not included 41A4680 Visor Clip 29C128 12V battery 10A14 FOR SERVICE, DIAL OUR TOLL-FREE NUMBER: 1-800-528-2817 114A1649C ©2001, The Chamberlain Group, Inc. All Rights Reserved Printed in Mexico