LiftMaster 61LM Owners Manual - Page 239

Model Series 850 Single-Function Remote Control Model Series 853 Multi-Function Remote Control Owner's Manual Model Series 856 Mini Multi-Function Remote Control F.C.C. rules prohibit adjustments to or modification of receiver and transmitter circuitry except for replacing the remote control battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. THIS DEVICE COMPLIES WITH FCC RULES PART 15. Operation of this device is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference that may be received, including interference that may cause undesired operation Manufactured under 1 or more of the following U.S. patents: RE29,525; 4,037,201; 4,750,118; 4,806,930. Other Patents Pending The 800 Series remote control (with green battery test light) works only with door openers and light controls having a green "SMART" button and green indicator light. Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the wall push button(s) or remote control(s). A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted. Programming instructions are described and illustrated below. The additional push buttons on the MultiFunction Remote Controls can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.) "SMART" GARAGE DOOR OPENERS (With Green "SMART" Button and Green Indicator Light) PROGRAM THE OPENER TO ACCEPT THE REMOTE CONTROL CODE Select a remote control push button to operate the opener. The large button is recommended for use with a garage door opener. Figure 1 Series 850 Series 856 Series 853 Select a remote control push button to operate opener Push Button 1. Press and HOLD the selected remote control push button (Figure 1). 2. Then press and release the green "SMART" button on the opener panel (Figure 2). The opener light will FLASH once. Release the remote control push button. Select a remote control push button to operate opener Now the opener has accepted the remote control code and will operate when the remote push button is pressed. NOTE: If the remote push button is not held down until the opener light flashes, the receiver will not learn the code. Figure 2 Garage Door Opener (With Green "SMART" Button) RED-1 WHT-2 BLK-3 If the green "SMART" button is pressed and held until the adjacent indicator light turns off (about 6 seconds), ALL the codes the opener has learned will be erased. Code programming instructions are also located on the opener panel. Green Green "SMART" Indicator Button Light H L I O G W H N O R M AL UP FORCE H L I O G W H N O R M AL DOWN FORCE Replacement Parts: Single-Function remote case, cover, Model 850CB screw (circuit board not included) Model 85ODI Model 850F Model 850MM Multi-Function remote case, cover, Model 853CB screw (circuit board not included) Model 853MM 41A3984-5 41A3984-1 41A3984-2 41A3984-3 41A3888-3 41A3888-2 Mini Multi-Function remote case, cover Model 856CB 41A3985-2 and interlocking touch tab strip Model 856DI 41A3985-3 (circuit board not included) Model 856F 41A3985-4 Model 856MM 41A3985-1 12 Volt battery 10A14 Visor Clip 29C128 FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 114A1542E © 1993, Chamberlain Group Inc. All Rights Reserved Printed in Mexico