LiftMaster 61LM Owners Manual - Page 197

For Service Dial Our Toll Free Number

Page 197 highlights

When Several Remotes operate one device: To match the 972LM to another CGI manufactured remote's code (Remote Control X): 1. Begin by having both the 972LM and Remote Control X available. 2. Press and hold both buttons on the 972LM until the yellow indicator light, visible on the bottom through a small hole, begins to blink. It will blink for 30 seconds; during this time it is in the learn or training mode, and the buttons can be released. 3. While it is in learn mode, hold Remote Control X, another CGI fixed or billion-code transmitter, back to back with FCC labels touching as illustrated. 4. Press and hold the Remote Control X push button as you slowly slide the remotes across each other until the 972LM indicator light blinks very rapidly, indicating it has learned the code. (If Remote Control X is also a 972LM, you must press and hold its right push button.) 5. The right button is now sending the same identical coded signal as Remote Control X. This code will remain inside the 972LM until replaced with another new code by repeating steps 1-4 above, or by resetting to Security✚. Yellow Indicator Light FCC Label Yellow Indicator Light Remote Control X Resetting the right push button back to Security✚ as follows. Push and hold both buttons while observing the small yellow indicator light. Hold both buttons for ten seconds until the yellow indicator light stops blinking. The remote has defaulted to one of six randomly preprogrammed Security✚ settings. The Remote Control Batteries WARNING To prevent possible SERIOUS INJURY or DEATH: CAUTION • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. The lithium batteries should pro- duce power for up to 5 years. To replace, pry open case with visor clip or screwdriver, as shown. Insert (+). batteries poAsitiVveEsidRe uTpISSEMENT Dispose of old batteries properly. ATTENTION Replacement Parts Model 972LM Security✚ remote case . . . . .41A5059-2 (circuit board not included) 3V2032 Lithium battery (2 required 10A20 Visor clip 29B137 FOR SERVICE DIAL OUR TOLL FREE NUMBER: US: 1-800-528-2817 CANADA: 1-800-654-4736 114A2209C © 2001, The Chamberlain Group, Inc. All Rights Reserved Printed in Mexico

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286

© 2001, The Chamberlain Group, Inc.
114A2209C
All Rights Reserved
Printed in Mexico
Replacement Parts
Model 972LM Security
remote case
. . . . .41A5059-2
(circuit board not included)
3V2032 Lithium battery (2 required) . . . . . . . . . .10A20
Visor clip
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
US: 1-800-528-2817
CANADA: 1-800-654-4736
1. Begin by having both the
972LM and Remote Control X
available.
2. Press and hold both buttons
on the 972LM until the yellow
indicator light, visible on the
bottom through a small hole,
begins to blink. It will blink for
30 seconds; during this time it
is in the learn or training
mode, and the buttons can be
released.
3. While it is in learn mode, hold
Remote Control X, another
CGI fixed or billion-code trans-
mitter, back to back with FCC
labels touching as illustrated.
4.
Press and hold the Remote
Control X push button
as you
slowly slide the remotes
across each other until the
972LM indicator light blinks
very rapidly, indicating it has
learned the code. (If Remote
Control X is also a 972LM,
you must press and hold its
right
push button.)
5.
The right button is now send-
ing the same identical coded
signal as Remote Control X.
This code will remain inside
the 972LM until replaced with
another new code by repeat-
ing steps 1-4 above, or by
resetting to Security
.
When Several Remotes operate one device:
To match the 972LM to another CGI manufactured
remote’s code (Remote Control X):
FCC Label
Remote Control X
Yellow
Indicator
Light
Resetting the right push button
back to Security
as follows.
Push and hold both buttons while
observing the small yellow indicator light.
Hold both buttons for ten seconds until
the yellow indicator light stops blinking.
The remote has defaulted to one of six
randomly preprogrammed Security
settings.
The Remote Control Batteries
The lithium batteries should pro-
duce power for up to 5 years.To
replace, pry open case with visor
clip or screwdriver, as shown.
Insert batteries
positive side up
(+).
Dispose of old batteries properly.
Yellow
Indicator
Light
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
WARNING