LiftMaster 61LM Owners Manual - Page 196

Model 972LM Security✚ 2 Channel Remote Control OWNER'S MANUAL WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: CAUTION • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until AVERTISSEMENT completely closed. Never permit anyone to cross path of moving gate or door. WARNING NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this receiv- er and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must WARNING accept any interference received, including interference that may cause undesired operation. Figure 1 Right Push Button (Multi-use) AVERTISSEMENT The 972LM remote control can activate two separate residential or commercial garage door openers and/or gate openers. ATTENTION AVERTISSEMENT The instructions for programming garage door openers are illustrated below. Please refer to the original receiver program- ming for commercial and gate products. Both push buttons are factory programmed to work with Security✚ receivers having an orange "learn" button. The rolling code between these channels and the receiver changes with each use, randomly accessing over 100 billion new codes. As an added feature, the push button on the right is capable of learning or being trained to duplicate or match another CGI manufactured fixed code or billion-code remote. This feature is normally used when several remotes are required to operate one fixed code device such as a gate opener or commercial dock door. In this case, the code transmitted to the receiver remains constant or fixed, not using the Security✚ format. Note: The push button on the left cannot be changed from Security✚, only the right button is trainable. Instructions are described and illustrated below. 1 2 3 9 1 7 3 5 KG 9 1 7 3 5 KG 1.Press and release the "learn" button 1 on the motor unit. The learn indicator light will glow steadily for 30 seconds. 2 3 KG KG 1 2 2. Within 30 seconds, press and hold the button on the hand-held remote that you wish to operate your garage door. 3. Release the button when the motor unit light blink. It has learned the code. If light bulbs are not installed, two clicks will be heard. To Erase All Codes From Motor Unit Memory 1 To deactivate any unwanted remote, first erase all codes: Press and the hold "learn" button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use. 2 3 KG KG