Linksys EFSP42 User Guide - Page 44
PSCONFIG, Enter, Available Options, Print Queue Information, Insert, Print Server Information
UPC - 745883549108
View all Linksys EFSP42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Instant EtherFast® Series 27. The setup is complete. The PrintServer will automatically log into your file server and make itself available for use. If you run your Console Monitor or other NetWare monitoring software, you will be able to verify the PrintServer's connection. Remote Printer Mode The instructions below explain how to configure the PrintServer for Remote Printer Mode, and establish communication between it and your NetWare 3.x network. Manual Setup 1. Run the PSCONFIG program under the D:\UTILITY\DOS directory of the Linksys PrintServer CD. 2. When the table of active devices appears, highlight the PrintServer device you want to configure and press Enter. 3. Choose Set to NetWare Remote Printer Mode from the Available Options menu and press Enter. 4. Make up a Print Server name and enter it. Write it down also - you will need it in a moment. 5. Enter the name of the existing print server resource name into Parallel Port 1. Do the same for Port 2 and Port 3 if you are adding printers to the PrintServer's second and third parallel ports. 6. Select the desired frame type for your network. 7. Select the Execute Setup. After the program is finished, press Esc repeatedly until the program closes. 8. Run NetWare's PCONSOLE program. 9. From the main menu, choose Print Queue Information. A list of available queues will appear. Press Insert. 10. Type in the name of the queue you want to create and press Enter. Repeat for each queue you want to create. When you're finished, press Esc to 82 EtherFast 10/100 PrintServers return to the main menu. Select Print Server Information from the main menu. 11. Select the print server resource that was already up and running when you began the PrintServer's software installation. 12. The Print Server Information screen will appear. Choose the Print Server Configuration menu item, followed by Printer Configuration. 13. A table of configured printers will appear. The first column shows the names of the configured printers; the second column shows the LPT ports on the PrintServer device. Zero refers to LPT1, 1 refers to LPT2, and 2 refers to LPT3. Press Enter and fill out the information. 14. Enter a name for the printer you're attaching to the PrintServer (Example: TARDIS). 15. Choose the Parallel or LPT port that the PrintServer should use. 16. Set Interrupts to No and leave the IRQ and Buffer entries blank. 17. Press Esc to exit. Your new printer will appear in the configured printers list. 18. Press Esc to return to the Print Server Configuration menu. 19. Choose Queues Serviced by Printer. A list of Defined Printers will appear. Select the printer you want to configure. 20. Press Insert. Choose the queue you created above. When asked for a Priority, press Enter. 21. Press Esc. Repeat steps 11 through 17 for each printer. When finished, press Esc repeatedly until the program closes. Unload and reload the print server resource on the file server. When PSERVER.NLM comes up, the newly installed printers will appear. 83