Lowrance HDS-7 Carbon Operators Manual EN - Page 64

5 Bearing line with allowed off course limit When travelling on a route the bearing line shows the intended course from one waypoint towards the next. When navigating towards a waypoint (cursor position, MOB, or an entered latitude and longitude position), the bearing line shows the intended course from the point at which navigation was started towards the waypoint. 6 Vessel symbol Indicates distance and bearing relative to the intended course. If the XTE (Cross Track Error) exceeds the defined XTE limit, this is indicated with a red arrow including the distance from the track line. Refer to "XTE limit" on page 66. Data Fields The Steer panel provides the following information: XTE Cross track error SOG Speed over ground COG Course over ground POS Position DTD Distance to destination TTD Time to destination Navigate to cursor position You can start navigating to a cursor position on any chart, radar, or Sonar panel. Position the cursor at the selected destination on the panel, and then select the Goto Cursor option in the menu. Ú Note: The Goto Cursor menu option is not available if you are already navigating. Navigate a route You can start navigating a route from the chart panel, steer panel, or from the Route dialog. 64 Navigating | HDS Carbon Operator Manual