Nikon COOLPIX S9500 Reference Manual - Page 41

The Basics of Shooting and Playback Step 1 Turn the Camera On Turning the Camera On and Off • When the camera is turned on, the power-on lamp (green) lights and the monitor is turned on (the power-on lamp turns off when the monitor is turned on). • To turn off the camera, press the power switch. Both the monitor and the power-on lamp are turned off. • To turn on the camera in playback mode, press and hold the c (playback) button. At this time, the lens does not extend. • When Record GPS data in GPS options of the GPS options menu is set to On, GPS functions will continue to operate even after the camera is turned off (A89). C Power Saving Function (Auto Off) If no operations are performed for a while, the monitor will turn off, the camera will enter standby mode, and the power-on lamp will flash. If no operations are performed for another 3 minutes, the camera will turn off automatically. • To turn on the monitor again in standby mode, perform either one of the following operations. - Press the power switch, shutter-release button, c button, or b (e movie-record) button. - Rotate the mode dial. • The time that elapses before the camera enters standby mode can be changed using the Auto off setting in the setup menu (A96). • By default, the camera enters standby mode in about 1 minute when you are using shooting mode or playback mode. • If you are using the AC Adapter EH-62F (available separately), the camera enters standby mode after 30 minutes. This setting cannot be changed. C Note on Battery Drain Battery power drains faster than usual while the camera is recording log data (A92) or using a Wi-Fi connection (A93). 19