Pioneer VSX-830-K Owner's Manual - Page 67

06 Basic playback Listening to the radio The following steps show you how to tune in to FM and AM radio broadcasts using the automatic (search) and manual (step) tuning functions. If you already know the frequency of the station you want, see Tuning directly to a station below. Once you are tuned to a station you can memorize the frequency for recall later-see Saving station presets on page 67 for more on how to do this. 1 Press TUNER to select the tuner. 2 Use BAND to change the band (FM or AM), if necessary. 3 Tune to a station. There are three ways to do this: ! Automatic tuning - To search for stations in the currently selected band, press and hold TUNE +/- for about a second. The receiver will start searching for the next station, stopping when it has found one. Repeat to search for other stations. ! Manual tuning - To change the frequency one step at a time, press TUNE +/-. ! High speed tuning - Press and hold TUNE +/- for high speed tuning. Release the button at the frequency you want. Improving FM sound VSX-1130 only If the TUNED or STEREO indicator doesn't light when tuning to an FM station because the signal is weak, press MPX to switch the receiver into mono reception mode. This should improve the sound quality and allow you to enjoy the broadcast. Tuning directly to a station 1 Press TUNER to select the tuner. 2 Use BAND to change the band (FM or AM), if necessary. 3 Press D.ACCESS (Direct Access). 4 Use the number buttons to enter the frequency of the radio station. For example, to tune to 106.00 (FM), press 1, 0, 6, 0, 0. If you make a mistake halfway through, press D.ACCESS twice to cancel the frequency and start over. Listening to station presets 1 Press TUNER to select the tuner. 2 Press CLASS to select the class in which the station is stored. Press repeatedly to cycle through classes A to G. 3 Press PRESET +/- to select the station preset you want. ! You can also use the number buttons on the remote control to recall the station preset. Naming station presets For easier identification, you can name your station presets. 1 Choose the station preset you want to name. See Listening to station presets on page 67 for how to do this. 2 Press TOOLS (TUNER EDIT). The display shows PRESET NAME, then a blinking cursor at the first character position. 3 Input the name you want. Use i/j (or TUNE i/j of front panel) to select a character, k/l (or PRESET k/l of front panel) to set the position, and ENTER to confirm your selection. Notes ! To erase a station name, simply repeat steps 1 to 3 and input eight spaces instead of a name. ! Once you have named a station preset, you can press DISP when listening to a station to switch the display between name and frequency. Saving station presets If you often listen to a particular radio station, it's convenient to have the receiver store the frequency for easy recall whenever you want to listen to that station. This saves the effort of manually tuning in each time. This receiver can memorize up to 63 stations, stored in seven banks, or classes (A to G) of 9 stations each. 1 Tune to a station you want to memorize. See Listening to the radio on page 67 for more on this. 2 Press TOOLS (TUNER EDIT). The display shows PRESET MEMORY, then a blinking memory class. 3 Press CLASS to select one of the seven classes, then press PRESET +/- to select the station preset you want. You can also use the number buttons to select a station preset. 4 Press ENTER. After pressing ENTER, the preset class and number stop blinking and the receiver stores the station. 67