Sharp MX-2310U Installation Manual - Page 22

6) Set the color patch image (adjustment pattern) printed in the procedure 5) on the document table. Set the color patch image (adjustment pattern) printed in the procedure 2) on the document table. Place the color patch image so that the fine lines are on the left side. At that time, place 5 sheets of white paper on the printed color patch image (adjustment pattern). PRINTER CALIBRATION 7) Select [FACTORY] target, and press [EXECUTE] key. When the color balance is customized with the manual color balance adjustment (SIM 67-25) according to the user's request and the color balance is registered as the service target with SIM 67-27, if the color balance is adjusted to that color balance, select the [SERVICE] target. ǂ7ǂ(6ǂ7 6,08/$7,21ǂǂ12 (1*,1($872$'-8670(176(59,&( 3/($6(:$,7 12:5(*,67(5,1*7+(1(:7$5*(72)+$/)721(352&2167  &/26( The printer color balance adjustment (step 1) is automatically performed and the color balance check patch image is printed out. If there is any streak or unclear print on the printed check pattern, check the print engine for any problems. PRINTER CALIBRATION Low density High density ; / % $M 0123 1) The max. density section is not blurred. 2) Patch C or D of each of Y, M, C, and BK is very slightly copied. 3) Patch for each of Y, M, C, BK The patch density is identical between patches or not reversed. The patch density is changed gradually. 8) The initial setting menu of the half tone image correction is displayed. Press [OK] key. The initial setting of the half tone image correction is performed. ǂ7ǂ(6ǂ7 6,08/$7,21ǂǂ12 (1*,1($872$'-8670(176(59,&( &21),507+($'-867('3$7&+$1'35(66>2.@725(*,67(57+,63$7&+'$7$   &/26( 2. 9) Wait until [EXECUTE] key is displayed. When it is displayed, press it. 2. The half tone image correction is performed. MX-2310U MX-2310U (MAIN UNIT) 2 - 13