Sony PXW-Z190 Operating Instructions - Page 123
months, How to avoid moisture condensation
View all Sony PXW-Z190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
wash off any liquid that may have contacted your skin. if any liquid gets in your eyes, wash with plenty of water and consult a doctor. When not using your camcorder for a long time • Turn on the camcorder and record and play back images about once a month to keep it in an optimum state for a long time. • Use up the battery pack completely before storing it. Moisture condensation If your camcorder is brought directly from a cold place to a warm place, moisture may condense inside your camcorder and cause a malfunction of your camcorder. If moisture condensation has occurred Leave your camcorder for about 1 hour without turning it on. Note on moisture condensation Moisture may condense when you bring your camcorder from a cold place into a warm place (or vice versa) or when you use your camcorder in a humid place as shown below. • When you bring your camcorder from a ski slope into a place warmed up by a heating device. • When you bring your camcorder from an air conditioned car or room into a hot place outside. • When you use your camcorder after a squall or a shower. • When you use your camcorder in a hot and humid place. How to avoid moisture condensation When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the ambient temperature (after about 1 hour). LCD screen • Do not exert excessive pressure on the LCD screen, as it may cause damage. • If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction. • While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction. To clean the LCD screen The surface of the LCD screen is coated. If you scratch the surface, the coating may be come off. Mind the following points when cleaning and handling it. • If hand grease or hand cream remains on the screen, the coating comes off more easily. Wipe it early. • The coating may be scratched if you wipe the screen with a tissue, etc. • Remove the dust or sand with a blower, etc. before wiping the dirt. • Use a soft cloth (a cloth for glasses, etc.) gently to clean the dirt. On handling the casing • If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth. • Avoid the following to avoid damage to the finish. Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen. Handling with above substances on your hands. Leaving the casing in contact with rubber or vinyl objects for a long period of time. About care and storage of the lens • Wipe the surface of the lens clean with a soft cloth in the following instances: When there are fingerprints on the lens surface. In hot or humid locations When the lens is exposed to salty air such as at the seaside. • Store in a well-ventilated location subject to little dirt or dust. • To prevent mold, periodically clean the lens as described above. On charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the ON/STANDBY switch is set to STANDBY. The pre-installed rechargeable battery is always charged while your camcorder is connected to the wall outlet (wall socket) via the AC Adapter or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all without the AC Adapter 123