Sony PXW-Z190 Operating Instructions - Page 42
Simultaneous recording in 2 slots, Simul Rec, Configuring before shooting
View all Sony PXW-Z190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Recording format MPEG HD422/ MPEG HD420 1080P System frequency 29.97/23.98 25 MPEG HD422 720P 59.94/29.97/ 23.98 50/25 S&Q frame rate 1 to 30 fps (1 FPS units) 1 to 25 fps (1 FPS units) 1 to 60 fps (1 FPS units) 1 to 50 fps (1 FPS units) MPEG HD422 and MPEG HD420 are displayed when the MPEG HD upgrade license (option) is installed. Notes • Slow & Quick Motion cannot be set during recording, playback, or while the thumbnail screen is displayed. • S&Q Motion cannot be set to On at the same time as Interval Rec, Picture Cache Rec, Clip Continuous Rec, 2-slot Simul Rec, Proxy Rec, or 4K & HD (Sub) Rec (when MPEG HD upgrade license (option) is installed). When S&Q Motion is set to On, these other recording modes are forcibly set to Off. • Audio recording is not supported in Slow & Quick Motion mode. Configuring before shooting Configure S&Q Motion (page 100) in the Recording menu before shooting. When Setting is set to On, Slow & Quick Motion mode is activated and "S&Q Stby" appears on the screen. Setting the recording frame rate using the direct menu You can set the recording frame rate in Slow & Quick Motion mode using the direct menu (page 36). Configuring using assignable buttons Assign S&Q Motion to an assignable button (page 38), and switch the Slow & Quick Motion mode On/Off by pressing the button. You can set the frame rate for recording by pressing and holding an assignable button to display the recording frame rate setup screen. Recording in Slow & Quick Motion mode Start the recording after completing the required setting. Press the record button. When you start recording, the "S&Q Stby" indication changes to "S&Q zRec." Notes • You cannot change the Frame Rate setting during Slow & Quick Motion recording. To change the settings, first stop recording. • Rec Review operation is not supported during Slow & Quick Motion recording. • The timecode is recorded in Rec Run mode during Slow & Quick Motion recording (page 100). • When you are recording with a slow frame rate, the camcorder may continue recording for a few more seconds after you press the record button to stop recording. To exit, stop the recording. To cancel Slow & Quick Motion mode In recording standby mode, set S&Q Motion >Setting in the Recording menu to Off, or press an assignable button assigned with S&Q Motion. Simultaneous recording in 2 slots (Simul Rec) You can simultaneously record using both memory cards A and B. Configuring before shooting Configure Simul Rec (page 101) in the Recording menu before shooting. Notes • 2-slot Simul Rec cannot be set to On at the same time as S&Q Motion, Interval Rec, Picture Cache Rec, Clip Continuous Rec, Proxy Rec, or 4K & HD (Sub) Rec (when MPEG HD upgrade license (option) is installed). When 2-slot Simul Rec is set to On, these other recording modes are forcibly set to Off. • 2-slot simultaneous recording is not supported when the recording format is QFHD mode (3840×2160P). If the recording format is set to QFHD mode when 2-slot Simul Rec is set to On, 2-slot Simul Rec is forcibly set to Off. Recording in 2-slot Simul Rec mode Start the recording after completing the required setting. Press the record button. Notes • Use the same type and same size of memory cards for 2-slot Simul Rec recording. • 2-slot Simul Rec cannot be set during recording, playback, or while the thumbnail screen is displayed. • When a memory card in one slot becomes full, if a memory card in the other slot is recordable, recording continues as normal. When you replace memory cards 42