Sony PXW-Z190 Operating Instructions - Page 38

Other faces (gray) Registered face frame (double white frame) Face selection cursor (orange) Clearing the registered face Move the selection cursor to the registered face using the V/v/B/b button, and press the SET button or SEL/SET dial. The registered face is cleared, the face frame becomes a single frame, and the registered face icon disappears. When faces are detected with the registered face frame not displayed and the face selection cursor (orange) displayed, you can clear the registered face by pressing the SET button or SEL/SET dial twice. Notes • Faces may not be detected depending on the recording environment, condition of the subject, or the settings. • You may not be able to get the proper effect, or objects other than people's faces may be detected as a face, in some recording environments. In this case, set the face detection AF function to Off. • Registration of the face of the intended individual for focusing before shooting is recommended. • Face registration may not be successful depending on hairstyle, facial decoration, or if not directly facing the camera. In this case, the face frame may become a double frame, but the registered face icon is not displayed. • If a face has already been registered, clearing the existing face and then registering the new face is recommended. • The registered face function is not available when Menu Settings >Direct Menu with (page 117) in the System menu is set to On. Switching face detection AF operation using an assignable button Assign Face Detection AF to an assignable button (page 38). You can then switch face detection AF operation in the order Face Priority AF, Face Only AF, and Off each time you press the button. Setting using the direct menu You can also set the face detection AF operation using the direct menu (page 36). Color bars/reference audio tone You can output color bars instead of the camera image by setting Color Bars (page 88) >Setting in the Camera menu to On. The image output is restored when set to Off. A 1 kHz reference audio tone can also be output with the color bars by setting Audio Input (page 94) >1kHz Tone on Color Bars in the Audio menu to On. The color-bar signal and reference-tone signal are output from the SDI OUT and HDMI OUT connectors. You can set the type of color bars using Color Bars >Type in the Camera menu. Notes • Color bars cannot be output when the camcorder is in Slow & Quick Motion mode. • You cannot switch to color bars while recording (switching from color bars to the camera image is available). Reviewing a recording (Rec Review) You can review the last recorded clip on the screen (Rec Review). When recording is stopped, press the assignable button assigned with Rec Review. The last 3 seconds, 10 seconds, or the entire clip is displayed, depending on the Rec Review (page 102) setting in the Recording menu. The clip is played to the end, Rec Review ends, and the camcorder returns to STBY (standby) mode. To stop Rec Review Press the STOP/CAM button or an assignable button assigned with Rec Review. Notes • Rec Review is not supported if the video format is changed after recording a clip. • The setup menus cannot be operated during Rec Review. Assignable buttons There are eight assignable buttons (page 7) on the camcorder to which you can assign functions. 38