Sony SDM-N80 Operating Instructions (primary manual) - Page 8
Step 3: Connect the display and media engine, Step 4: Connect the audio cord
View all Sony SDM-N80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Step 3: Connect the display and media engine Turn off the display and media engine before connecting them. To connect the system connecting cable to the display easily, set the display in an upright position. A to SYSTEM CONNECTOR of the display Step 5: Connect the power cord With the media engine, display, and computer switched off, first connect the power cord to the media engine, then connect it to a power outlet. to AC IN connector to a power outlet Power cord (supplied) System connecting cable (2 m) (supplied) A to SYSTEM CONNECTOR of the media engine Align the v on the plugs with the v on the display and the media engine. Caution Be sure to install the media engine vertically as shown above. Installing the media engine lying flat may block ventilation, and may cause a malfunction. Note When connecting the cable, grasp the plug and insert it firmly into the connector until you hear it click. When disconnecting the cable, pull out the plug while holding down locking lever A. Step 4: Connect the audio cord Step 6: Turn on the monitor and computer 1 Turn on the media engine. The display automatically turns on. The indicators of the media engine and display light up in green. 2 Turn on the computer. Note If you turn off the media engine and turn it on again while the display is off, the display will not turn on automatically. In this case, press the 1 (power) switch on the display to turn it on. to an audio output jack on your computer to AUDIO IN jack among the INPUT2 connectors Audio cord (supplied) 8