TRENDnet TPE-1620WS User's Guide - Page 32

TRENDnet User's Guide Mirroring Configure port mirror settings Bridge > Mirroring Port mirroring allows you to monitor the ingress and egress traffic on a port by having the traffic copied to another port where a computer or device can be set up to capture the data for monitoring and troubleshooting purposes. 1. Log into your switch management page (see "Access your switch management page" on page 11). 2. Click on Bridge, click on Trunk Config, and click on Port Priority. TPE-1620WS To copy data transmitted on specific port, check the port number under the Egress Port section or you could click All to copy data transmitted on all ports. 3. Review the settings. Click Apply to save changes. • Status - Click the drop-down and list and select one of the following options: o Enable - This parameter activates the Port Mirroring feature and the rest of the configuration parameters become active on the page. o Disable - This parameter de-activates the Port Mirroring feature and the rest of the configuration parameters become inactive on the page. • Mirror Target Port - Click the drop-down and list and select the port to send the copied ingress/egress packets/data. (e.g. Computer or device with packet capture or data analysis program.) 4. Click Save Settings to Flash (menu). 5. Click Save Settings to Flash (button), then click OK. Note: This step saves all configuration changes to the NV-RAM to ensure that if the switch is rebooted or power cycled, the configuration changes will still be applied. Check the port to monitor or copy inormation from. (Source) To copy data received on a specific port, check the port number(s) under the Ingress Port section or you could click All to copy data received on all ports. © Copyright 2013 TRENDnet. All Rights Reserved. 32