TRENDnet TPE-1620WS User's Guide - Page 56
Destination IP MAC Mask Length
View all TRENDnet TPE-1620WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
TRENDnet User's Guide Add L2+IPv4 To add an L2+IPv4 policy, use the following procedure: • Click Add L2+ IPv4, The Policy Settings page. • Enter a number in the Policy Index field. The Policy Index is a unique number within the range of 1 - 65535 which identifies the policy. This field is mandatory. • Choose the parameters to add for the policy, and enter data one or more of the parameters required for your policy. They are listed here: o Source MAC Address - Specifies the source MAC address. The format is xx.xx.xx.xx.xx.xx. o Source MAC Mask Length - Indicates the length of the Source MAC Mask ranging from 1- 48. o Destination MAC Address - Specifies the destination MAC address. The format is xx.xx.xx.xx.xx.xx. o Destination MAC Mask Length - Indicates the length of the Destination MAC Mask ranging from 1 - 48. o VLAN ID - A unique number identifying a VLAN ranging from 1 to 4094. o 802.1p Priority - 802.1p priority level of the frame ranging from 0 to 7. o Ether Type - Indicates the protocol of the ethernet frame protocol ranging from 0000 to FFFF. o Protocol - Indicates the packet protocol ranging from 0 to 255. o Source IP Address - Specifies the source IP address. o Source IP Mask Length - Specifies the mask length of the source IP address ranging from 0 - 32. o Destination IP Address - Specifies the destination IP address. o Destination IP MAC Mask Length - Specifies the mask length of the destination IP address ranging from 0 - 32. o DSCP - The DSCP (Differentiated Services Code Point) value in the IP header ranging from 0 - 63. o Source Layer 4 Port - Indicates the source layer 4 port ranging from 1 - 65535. © Copyright 2013 TRENDnet. All Rights Reserved. TPE-1620WS o Destination Layer 4 Port - Indicates the destination layer 4 port ranging from 1 - 65535. o Policy Sequence: Enter a number in the Policy Sequence field. The Policy Sequence must be a unique number within the range of 1 65535. This field is mandatory. o Policy Action: In the Permit/Deny field, use the pull down menu to select one of the following parameters: o Deny - This selection drops ingress packets that conform to the specified Replaced-CoS or Replaced-DSCP. o Permit - This selection allows ingress packets that conform to the specified Replaced-CoS or Replaced-DSCP to be processed by the switch. Note: You must enter a selection for Deny/Permit field even if the Profile Action ID that you have entered ignores both the ReplacedDSCP and Replaced-CoS fields. o Replaced-CoS: Enter a number in the Replaced-CoS field ranging from 0 to 7. This field indicates the CoS level of interest. This field is not mandatory and you may elect to leave it blank o Replaced-DSCP: Enter a number in the Replaced-DSCP field within the range of 0 to 63. This field indicates the DSCP level of interest. This field is not mandatory and you may elect to leave it blank. o Rate Control Index: The Rate Control Index is a unique number within the range of 1 - 65535. This field is mandatory and must match a Port List Index that has been previously entered on the Policy Index. o Port List: Select the interface for which you want to display data. • Click Add to add the policy to the Policy Table. 56