TRENDnet TPE-1620WS User's Guide - Page 89
Network Connectivity Test (Ping Tool), Software Method Switch Management
View all TRENDnet TPE-1620WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
TRENDnet User's Guide To reset your switch to factory defaults: You may want to reset your router to factory defaults if you are encountering difficulties with your router and have attempted all other troubleshooting. Before you reset your router to defaults, if possible, you should backup your router configuration first, see "Backup and restore your router configuration settings" on page 44. There are two methods that can be used to reset your router to factory defaults. • Hardware Method: Using a paper clip, on the front panel of the switch, push and hold the Reset button more than 10 seconds and release. Located on the front panel of your switch, see "Product Hardware Features" on page 6. Use this method if you are encountering difficulties with accessing your switch management page. • Software Method (Switch Management Page): 1. Log into your switch management page (see "Access your switch management page" on page 11). 2. Click on Tools and click on Reboot. 3. Click the Reboot Type drop-down list and select from one of the following options • Factory Default: Resets all switch configuration settings to factory defaults including the IP address. • Factory Default Except IP: Resets all switch configuration settings to factory defaults and leaves the current IP address configuration. TPE-1620WS Network Connectivity Test (Ping Tool) Tools > IEEE 802.3az EEE This chapter provides the procedure to ping a node on your network from the switch. This procedure is useful in determining whether an active link exists between the switch and another network device. The device you are pinging must be a member of the Default VLAN and within the same local area network as your switch. In other words, the port on the switch through which the node is communicating with the switch must be an untagged or tagged member of the Default VLAN. 1. Log into your switch management page (see "Access your switch management page" on page 11). 2. Click on Tools and click on Ping. 3. Review the settings. Click Start to start the network connectivity ping test. After the ping test is activate, you can click Show Ping Results to check the ping test result. • Destination IP Address - The IP address of the node you want to ping in the IPv4 or IPv6 format. • Timeout Value - Specifies the length of time, in seconds, the switch waits for a response before assuming that a ping has failed. • Number of Ping Requests - Specifies the number of ping requests you want the switch to perform. The switch factory default settings are below. Administrator User Name admin Administrator Password admin Switch IP Address 192.168.10.200 Switch Subnet Mask 255.255.255.0 © Copyright 2013 TRENDnet. All Rights Reserved. 89