TRENDnet TPE-1620WS User's Guide - Page 45
Set GVRP time settings
View all TRENDnet TPE-1620WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
TRENDnet User's Guide Set GVRP time settings Bridge > GVRP > Time Settings This section will allow you to define the GARP Join, Leave, and Leave All Time for each port. Note: The GARPLeaveTimer must be greater than (GARPJoinTimer x2 + 10) and the GARPLeaveAllTimer must be greater than (GARPLeaveTimer + 10). The acceptable input values are multiples of 10. If you try to enter a value that is not a multiple of 10, the value is rounded down 1. Log into your switch management page (see "Access your switch management page" on page 11). 2. Click on Bridge, click on GVRP and click on Time Settings. 3. Review the settings for each port. Click Apply to save the settings. • Port - This parameter displays the ports on the switch. • JoinTime - This parameter is the GARP Join Timer. Its range is 10 - 1073741810 milli-seconds. • LeaveTime - This parameter is the GARP Leave Timer. Its range is 30 2147483630 milli-seconds. This timer must be set in relation to the GVRP Join Timer according to the following equation: • GARPLeaveTimer >= (GARPJoinTimer X 2) + 10 • GarpLeaveAllTime - This parameter is the GARP Leave Timer. Its range is 30 2147483630 milli-seconds. This timer must be set in relation to the GVRP Leave Timer according to the following equation: • GARPLeaveAllTimer > (GARPLeaveTimer + 10) Note: To ensure compatibility between network devices, you need to configure the same values for the GARP Join Timer, GARP Leave Timer, and GARP Leave All Timer on all participating GVRP devices in your network. TPE-1620WS 4. Click Save Settings to Flash (menu). 5. Click Save Settings to Flash (button), then click OK. Note: This step saves all configuration changes to the NV-RAM to ensure that if the switch is rebooted or power cycled, the configuration changes will still be applied. © Copyright 2013 TRENDnet. All Rights Reserved. 45