Toshiba Qosmio G40 PQG40C-MM108C Users Manual Canada; English - Page 215

Troubleshooting Problem Display error occurs Procedure Check that the cable connecting the external monitor to the computer is firmly attached. If you are still unable to resolve the problem, contact your reseller, dealer or service provider. Modem For additional information, please also refer to Appendix C, AT Commands and Appendix D, S-registers. This information is applicable to the models equipped with a built-in modem. Problem Procedure Communication software can't initialize modem Make sure the computer's internal modem settings are correct - please refer to the Phone and Modem Options link within the Windows Control Panel. You can hear a dial tone but can't make a call If the call is going through a Private Branch Exchange (PBX), take care to ensure that the communication application's tone dial detection feature is disabled. You are also able to use the ATX command please refer to Appendix C, AT Commands for further information. You place a call, but a Make sure that the settings are correct within connection can't be your communication application. made After making a call you can't hear a ring Ensure that the communication application's tone or pule dialling selection feature is set correctly. You are also able to use the ATD command please refer to Appendix C, AT Commands for further information. Communication is cut off unexpectedly The computer will automatically cut off communication when connection with the carrier is not successful for a set time interval - try lengthening this time interval within your communication application. A CONNECT display is quickly replaced by NO CARRIER Ensure that the communication application's error control feature is set correctly. You are also able to use the AT\N command please refer to Appendix C, AT Commands for further information. User's Manual 10-21