Yamaha RX-V2065 Owner's Manual - Page 77

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Advanced setup In the advanced setup menu, you can set basic operations of this unit, such as on and off of a bi-amp connection, or initialize user settings. 1 Set this unit to standby. 2 While holding down QSTRAIGHT on the front panel, press LMAIN ZONE ON/OFF. Keep holding down QSTRAIGHT until "ADVANCED SETUP" appears on the front panel display. ADVANCED SETUP 3 Rotate the PPROGRAM selector to select the parameter you want to change. The default setting are marked with "*". y • Set values are placed in XXX of the following parameters on an actual display screen. SP IMP. -XXX Choices: 6ΩMIN, 8ΩMIN* Selects output impedance of this unit according to connected speakers. When you connect 4-ohm speakers to the FRONT speaker terminals, set "SP IMP." to "6ΩMIN.". RS232C STBY -X Choices: Y (Yes)*, N (No) Selects whether or not to transmit data via the RS232C terminal when this unit is in the standby mode. REMOTE ID -XXX Choices: ID1*, ID2 Sets a remote control ID. When using multiple Yamaha AV receivers, you can operate them with a single remote control by setting the receiver IDs to the same setting. SR PIN -XXX Choices: RESET, CANCEL* Resets Parental lock cord when using SIRIUS Satellite tuner. BI AMP - XXX Choices: ON, OFF* Switches on and off of bi-amp connection of main speakers. For bi-amp connection, see page 12. SCENE IR -XXX Choices: ON*, OFF Selects whether or not to transmit the control signals to an external component connected to the REMOTE OUT jack on this unit when BD/DVD or CD SCENE function is selected. MON.CHK - XXXX Choices: YES*, SKIP Adds upscaling limitation on output signals to a video monitor connected to this unit via the HDMI OUT jack. INIT-XXXXXXXXX Choices: DSP PARAM, VIDEO, NETWORK, ALL, CANCEL* Initializes various settings stored in this unit. You can select an initialization method from the following. DSP PARAM: All parameters of sound field programs VIDEO Video conversion settings (resolution/ aspect) in the Setup menu and the GUI display position NETWORK Network settings in the Setup menu ALL All CANCEL Cancellation of initialization USB FirmUpdate NET FirmUpdate Updates the firmware of this unit. For details on how to update the firmware, refer to information supplied with updates. Notes • Do not use this feature unless you need to update the firmware. • Be sure to read information supplied with updates before updating the firmware. VERXXX.XXX.XXX Displays the firmware of this unit. 4 Press OSTRAIGHT repeatedly to change the selected parameter setting. To change other settings, repeat steps 3 and 4. 5 Press KMAIN ZONE ON/OFF to set this unit to standby. The settings you made are reflected next time you turn on this unit. ADDITIONAL INFORMATION APPENDIX English 73 En