Yamaha RX-V2065 Owner's Manual - Page 85
SIRIUS Satellite Radio U.S.A. model only - firmware update
UPC - 027108933948
View all Yamaha RX-V2065 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Troubleshooting Status message NO SIGNAL CHANNEL OFF AIR CHANNEL NOT AUTHORIZED CHANNEL NOT AVAILABLE - - - - Cause Remedy The XM Mini-Tuner is not receiving the XM satellite signal. Something may be blocking the XM antenna's view of the satellites or the antenna is not properly aimed. Check for antenna obstructions and reposition the XM antenna to get better signal reception. Use the "Antenna" information on the front panel display or XM information on the GUI screen to check the antenna reception level. See instructions supplied with the XM Mini-Tuner and Dock for antenna installation information. The XM channel you selected is not currently broadcasting. Check back at a later time; in the meantime, select another channel. You may be attempting to tune to an XM channel that is blocked or that you cannot receive with your XM subscription package. Consult the latest channel guide at http://www.xmradio.com/ for the current list of channels. For information on receiving this channel, visit http://www.xmradio.com/ or contact XM Satellite Radio at 1-800-967-2346. The selected channel is not available. The channel may have been reassigned to a different channel number. This message may occur initially with a new XM MiniTuner or an XM Mini-Tuner that has not received XM's signal for an extended period. Consult the latest channel guide at http://www.xmradio.com/ for the current list of channels. For cases of a new XM Mini-Tuner or an XM Mini-Tuner that has not received XM's signal for an extended period, allow the XM Mini-Tuner to receive the XM satellite signal for at least 5 minutes and then try to select the channel again. No artist name or song title is available for No action required. this selection. See page 38 - - - - SIRIUS Satellite Radio (U.S.A. model only) If an operation takes longer than usual or an error occurs, one of the following messages may appear on the GUI screen. In this case, read the cause and follow the corresponding remedies. Status message Cause Remedy ANTENNA ERROR SIRIUS LOADING CHECK SIRIUS TUNER NOT SUPPORTED ACQUIRING SIGNAL UPDATING F/W UPDATING The antenna is not connected to the SiriusConnect tuner properly. This unit is communicating with the SiriusConnect tuner. The SiriusConnect tuner is not connected to the SIRIUS jack of this unit correctly. The SiriusConnect tuner is not connected to the AC wall outlet. This unit does not support the connected SIRIUS Satellite Radio tuner. The signal is too weak. The SiriusConnect tuner is updating the channel list. The period of the subscription is end. The SiriusConnect tuner is updating the firmware. Check the connection of the antenna and SiriusConnect tuner. The message disappears normally within several tens of seconds. Check the connection of the SiriusConnect tuner and this unit. Connect the power cable of the SiriusConnect tuner to the AC wall outlet. Connect the SiriusConnect tuner that this unit supports, Adjust the orientation of the antenna of the SiriusConnect tuner. Use the "Antenna" information on the front panel display or SIRIUS information on the GUI screen to check the antenna reception level. Wait until the updating is complete. Contact SIRIUS Satellite Radio to renew the subscription. Wait until the updating is complete. See page 39 - 39 39 39 43 - 39 - APPENDIX English 81 En