ZyXEL GS2200-8 User Guide - Page 80

Chapter 8 Basic Setting Click the PoE Setup link in the Basic Setting > PoE Status screen. The following screen opens. Figure 48 Basic Setting > PoE > PoE Setup The following table describes the labels in this screen. Table 15 Basic Setting > PoE > PoE Setup LABEL PoE Mode DESCRIPTION Select the power management mode you want the Switch to use. Port PD • Classification - Select this if you want the Switch to reserve the Max Power (mW) to each PD according to the power classification of the PD. If the total power supply runs out, PDs with lower priority do not get power to function. • Consumption - Select this if you want the Switch to manage the total power supply so that each connected PD gets a resource. However, the power allocated by the Switch may be less than the Max Power (mW) of the PD. PDs with higher priority also get more power than those with lower priority levels. This is the port index number. Select this to provide power to a PD connected to the port. PD Priority If left unchecked, the PD connected to the port cannot receive power from the Switch. This field is only available on the PWR model but not available for the Gigabit or mini-GBIC ports. When the total power requested by the PDs exceeds the total PoE power budget on the Switch, you can set the PD priority to allow the Switch to provide power to ports with higher priority. Select Critical to give the highest PD priority on the port. Select High to set the Switch to assign the remaining power to the port after all critical priority ports are served. Select Low to set the Switch to assign the remaining power to the port after all critical and high priority ports are served. 80 GS2200-8/24 User's Guide