2011 Subaru Outback Owner's Manual - Page 104

Keys and doors 2-13 sary to program the transmitter's code (identification number) into the system. A tag showing the code is affixed to the key unit, and another is affixed to the circuit board inside the transmitter. If there is no tag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure. 1. Firmly close the doors and the rear gate (Outback) or trunk lid (Legacy). 2. Open the driver's door, sit in the driver's seat, and close the door. 3. Perform the following steps within 45 seconds. NOTE . When part 4 of the procedure is completed, an electronic tone will sound for 30 seconds. . If you do not perform the operations in part 4 within 15 seconds, an error will occur and the electronic tone will not sound. In this event, perform the registration steps again beginning with part 3 of the procedure. 1) 2) LOCK ON (2) Insert the key into the ignition switch, then turn it from the "LOCK" position to the "ON" position 10 times within 15 seconds. NOTE . When you complete step (2), an electronic tone will sound once. . If you do not perform steps (1) and (2) within 45 seconds, an error will occur. An electronic tone will not sound. In this event, perform the whole procedure again beginning with part 1. (1) Open and close the driver's door once. 4. Open and close the door once within 15 seconds. 5. Before the electronic tone stops sounding, press the lock side of the power door lock switch the same number of times as the leftmost digit of the transmitter code. For example, press the lock switch eight times if the leftmost digit of the code is 8. - CONTINUED -