2011 Subaru Outback Owner's Manual - Page 206

Audio 5-15 . If you drive under a bridge . If you are driving next to a tall vehicle (such as a truck or a bus) that blocks the signal . If you are driving in a valley where the surrounding hills or peaks block the signal from the south . If you are driving on a mountain road where the southern direction is blocked by mountains unforeseen circumstances when there are problems with the reception of XMTM satellite radio signals. & Band selection & Displaying satellite radio ID of tuner When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID. The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support. The satellite radio ID can be found on the audio display by tuning the channel to "000". Turn the "TUNE/TRACK/CH" dial to select the satellite radio channel. NOTE For Sirius, change the display to an indication mode other than the channel number after performing the above operation. Press the "SAT" button when the radio is off to turn on the radio. Press the "SAT" button when the radio is on to select SAT1, SAT2 or SAT3 reception. . If you are driving in an area with tall trees that block the signal (10 m or more), for example on a road that goes through a dense forest . The signal can become weak in some areas that are not covered by the repeater station network. Please note that these may be other - CONTINUED -