2011 Subaru Outback Owner's Manual - Page 209

5-18 Audio ! How to preset channels 1. Press the "SAT" button to select SAT1, SAT2 and SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. & Display selection CD player operation NOTE . Make sure to always insert a disc with the label side up. If a disc is inserted with the label side down, the player displays "CHECK DISC". Refer to "When the following messages are displayed" F5-27. . If a disc is inserted during a radio broadcast, the disc will interrupt the broadcast. . After the last track finishes, the disc will automatically return to track 1 (the first track on the disc) and will automatically play back. . The player is designed to be able to play music CD-Rs and music CD-RWs, but it may not be able to play certain ones. . CDs (i.e., 8 cm/3 inch CDs) are not supported, and if inserted, they will be immediately ejected. . Copyright protected WMA/AAC files will not be played by the system. The player will automatically skip to the next file (track). . Audio data recorded in the MP3/ WMA/AAC formats may not be played depending on the data recording condition. NOTE If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels. ! Selecting preset channels Presetting a channel with a preset button allows you to select that channel in a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset. Press the "TEXT" button while receiving the satellite radio to change the display as follows: