2011 Subaru Outback Owner's Manual - Page 134

Instruments and controls 3-13 warning light/malfunction indicator lamp turn off immediately. It may take several driving trips. If the light does not turn off, take your vehicle to your authorized SUBARU dealer immediately. ! If the light is blinking If the light is blinking while driving, an engine misfire condition has been detected which may damage the emission control system. To prevent serious damage to the emission control system, you should conform to the following instructions. . Reduce vehicle speed. . Avoid hard acceleration. . Avoid steep uphill grades. . Reduce the amount of cargo, if possible. . Stop towing a trailer as soon as possible. The CHECK ENGINE warning light/malfunction indicator lamp may stop blinking and illuminate steadily after several driving trips. You should have your vehicle checked by an authorized SUBARU dealer immediately. & Coolant temperature low indicator light/Coolant temperature high warning light CAUTION . After turning the ignition switch to the "ON" position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfunctioning. Contact your SUBARU dealer immediately for an inspection. - It remains blinking in RED. - It remains illuminated in RED for more than 2 seconds. - It remains blinking in RED and BLUE alternately. . While driving, if this indicator light/warning light behaves under any of the following conditions, take the specified appropriate measure listed below. - Blinking in RED: Decelerate the vehicle. After the blinking RED light turns off, you can drive the vehicle normally. - Illuminated in RED: Safely stop the vehicle as soon as possible, and refer to the emergency steps for the case of engine overheating. After that, have the system checked by your nearest SUBARU dealer. Refer to "Engine overheating" F9-12. - Blinking in RED and BLUE alternately: The electrical system may be malfunctioning. Contact your SUBARU dealer for an inspection. This coolant temperature low indicator light/coolant temperature high warning light has the following three functions. . Illumination in BLUE indicates insufficient warming up of the engine . Blinking in RED indicates that the engine is close to overheating . Illumination in RED indicates overheating condition of the engine For the system check, this indicator light/ warning light illuminates in RED for approximately 2 seconds when the ignition switch is turned to the "ON" position. After that, this indicator light/warning light changes to BLUE and maintains illumination in BLUE. This BLUE illuminated light - CONTINUED -