2011 Subaru Outback Owner's Manual - Page 127

3-6 Instruments and controls " " on the trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob. needles when the ignition switch is in the "ON" position. Change the setting when the ignition switch is in the "LOCK" or "Acc" position. & Speedometer The speedometer shows the vehicle speed. seconds of illumination of the odometer/ trip meter, the odometer/trip meter will turn off. Also, if you open and close the driver's door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. & Odometer & Double trip meter *1: " " or " " and " " or " " cannot be displayed when the ignition switch is in the "ON" position. *2: MT models only 3. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated This meter displays the two trip meters when the ignition switch is in the "ON" position. The trip meter shows the distance that the vehicle has been driven since you last set it to zero. If you press the trip knob when the ignition switch is in the "LOCK" or "Acc" position, the odometer/trip meter will light up. It is NOTE . Your vehicle's initial movement setting of the meter/gauge needles has been set for activation " " at the time of shipment from the factory. . It is not possible to change the initial movement setting of the meter/gauge This meter displays the odometer when the ignition switch is in the "ON" position. The odometer shows the total distance that the vehicle has been driven. If you press the trip knob when the ignition switch is in the "LOCK" or "Acc" position, the odometer/trip meter will light up. If you do not press the trip knob within 10