2011 Subaru Outback Owner's Manual - Page 168

Instruments and controls 3-47 ! Compass calibration 1. If a "C" is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. Your can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be calibrated once it has tracked a complete circle. 4. To recalibrate your compass, push and hold the compass display button for 9 seconds until a "C" appears in the compass window. 5. Calibrate the compass according to step 2 or step 3. ! HomeLink® Wireless Control System The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three HomeLink® buttons on the mirror, each of which can be programmed for operation of one desired device. For details on the device types which can be operated by this system, consult the HomeLink® website at: www.homelink.com or call 1-800-3553515. Note the following information about this system. If your vehicle is equipped with the HomeLink® Wireless Control System, it complies with Part 15 of the Federal Communications Commission Rules in the U.S. and the RSS-210 of Industry Canada in Canada. Its operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes and modifications to this system by anyone other than an authorized service facility could void authorization to use this equipment. HomeLink® and the HomeLink® house are registered trademarks of Johnson Controls, Inc. and objects are out of the way of the garage door or other device to prevent potential harm or damage. . Do not use the HomeLink® Wireless Control System with a garage door opener that lacks the safety stop and reverse feature as required by applicable safety standards. A garage door opener which cannot detect an object, signaling the door to stop and reverse, does not meet these safety standards. Using a garage door opener without these features increases risk of serious injury or death. For more information, consult the HomeLink® website at www.homelink.com or call 1-800-355-3515. CAUTION When programming the HomeLink® Wireless Control System to operate a garage door opener or an entrance gate, unplug the device's motor from the outlet during programming to prevent motor burnout. WARNING . When programming the HomeLink® Wireless Control System, you may be operating a garage door opener or other device. Make sure that people - CONTINUED -