2011 Subaru Outback Owner's Manual - Page 165

3-44 Instruments and controls & Auto-dimming mirror with compass (if equipped) is to ensure good reward visibility during reversing. . By pressing and releasing the switch for 3 seconds, the compass display is toggled on or off. When the compass is on, an illuminated compass reading will appear in the upper right corner of the mirror. When cleaning the mirror, use a paper towel or similar material dampened with glass cleaner. Do not spray glass cleaner directly on the mirror as that may cause the liquid cleaner to enter the mirror housing and damage the mirror. 1) 2) 3) HomeLink® button 1 HomeLink® button 2 HomeLink® button 3 1. Press and hold the two outer buttons (button 1 and button 3) until the indicator light begins to flash (after approximately 20 seconds). 2. Release both buttons. ! In case a problem occurs If you cannot activate a device using the corresponding HomeLink® button after programming, contact HomeLink® at www.homelink.com or call 1-800-3553515 for assistance. 1) 2) 3) 4) LED Switch Sensor Compass display ! Photosensors The auto-dimming mirror has an anti-glare feature which automatically reduces glare coming from headlights of vehicles behind you. It also contains a built-in compass. . By pressing and holding the switch for less than 3 seconds, the automatic dimming function is toggled on or off. When the automatic dimming function is on, the LED indicator will illuminate. Even with the mirror in anti-glare mode, the mirror surface turns bright if the transmission is shifted into reverse. This The mirror has a photosensor attached on the front and back sides. During nighttime driving, these sensors detect distracting