2011 Subaru Outback Owner's Manual - Page 160

Instruments and controls 3-39 mode, press and hold the power button for 12 to 15 seconds while the transmission is in the "R" (reverse) position, and then release it. The display is now in the nonoperational mode. After the display has been set to the non-operational mode, the function indicator will illuminate in orange while the transmission is in the "R" (reverse) position. To return the display to the operational mode, press and hold the power button for 12 to 15 seconds again. For precautions about the rear view camera and the rear view image, refer to "Rear view camera" F6-18. ! Electronic compass display By briefly pressing the compass button, the compass display is toggled on or off. When the compass display is on, an illuminated compass reading will appear on the mirror. Using the electronic compass properly, the following compass zone adjustment and compass calibration will be necessary. ! Compass zone adjustment ! Compass calibration 1. For optimum calibration, switch off all nonessential electrical accessories (rear window defogger, heater/air conditioning system, spotlight, etc.) and ensure all doors are shut. 2. Drive to an open, level area away from large metallic objects or structures and make certain the ignition switch is in the "ON" position. 3. Press and hold the compass button for 6 to 9 seconds, and then release it. The compass will enter the calibration mode, then "C" and the direction will be displayed. 4. Drive slowly in a circle until "C" disappears from the display. Driving in two or three circles might be necessary. The compass is now calibrated. 5. Further calibration may be necessary should outside influences cause the compass to read inaccurately. You will notice any outside influence if the compass tends to read in only one particular direction. Should you encounter this situation, return to step 1 of the above procedure and recalibrate the compass. Compass calibration zones 1. Refer to the "Compass calibration zones" map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the compass button for 3 to 6 seconds, and then release it. The zone number will be shown on the electronic compass display. 3. Press the compass button repeatedly until the correct zone number for your location is displayed. 4. Releasing the button for 3 seconds will exit the zone setting mode. - CONTINUED -