2011 Subaru Outback Owner's Manual - Page 271

7-14 Starting and operating & Service mode In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced. To engage or disengage service mode: 1. Enter the vehicle and close all vehicle doors and the trunk/rear gate. 2. Verify that the select lever is in the "P" position (AT and CVT models) 3. Depress and hold the brake pedal 4. Turn the ignition switch to the "ON" position 5. Press and release the remote engine start transmitter " " button three times. The system will honk the vehicle's horn each time the button is pressed. 6. The system will pause for 1 second then honk the vehicle's horn three times to indicate that the service mode has been engaged or honk one time to indicate that the service mode has been disengaged. & Remote transmitter program New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to eight transmitters). New remote engine start transmitters can be programmed according to the following procedure. 1. Open the driver's door (the driver's door must remain opened throughout the entire process). 2. Depress and hold the brake pedal. 3. Turn the ignition switch to "ON" then "LOCK", back to "ON" then "LOCK", then back to "ON" again and leave the ignition "ON" throughout the programming process. 4. The system will flash the side marker lights, tail lights and front position lights and honk the horn three times, indicating that the system has entered the transmitter learn mode. 5. Press and release the " " button on the transmitter that you want to program. 6. The system will flash the side marker lights, tail lights and front position lights and honk the horn one time, indicating that the system has learned the transmitter. Upon successful programming, the remote start confirmation transmitter button will flash one time. 7. Repeat step 5 for any additional transmitters (the system will accept up to eight transmitters). 8. The system will exit the transmitter learn mode if the key is turned to the "LOCK" position, the door is closed or after 2 minutes. & System maintenance NOTE In the event that the vehicle's battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is required to allow the vehicle electronic systems to resynchronize. ! Changing the batteries CAUTION . Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. . Be careful not to damage the printed circuit board in the remote engine start transmitter when replacing the battery. NOTE When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.