Acer R5250-Q2000 Configuration Guide - Page 111

system into text mode and install the driver for ATI FireGL V5200 first. NOTE. For installing the ATI FireGL V5200 driver, additional packages are required. Please refer to the Installation Tips section for which packages should be installed. 1. When the system stopped after OS installation completed, please power off the system than power on it again. 2. Please select SUSE Linux Enterprise Server 10 (Failsafe) at boot select menu. 3. After you the system boot into text mode, copy the ATI driver installer to HDD. 4. Go to the directory that includes the ATI driver installer and run the ATI driver installer. # ./ati-driver-installer-8.35.5-x86.x86_64.run 5. Follow the instructions and use the default settings to install the driver. 6. After the driver is installed, run "aticonfig --initial" to configure the driver. # aticonfig --initial Uninitialised file found, Configuring. Using /etc/X11/xorg.conf Save back-up to /etc/X11/xorg.conf.original-0 7. Please reboot the system. 8. If you want to change the display setting, please DO NOT use the OS built-in utility. Please use the ATI Catalyst Control Center instead by "amdcccle" command. # amdcccle Gigabit Ethernet Driver Installation 1. You can find the onboard NVIDIA nForce Networking Controller driver in EasyBUILD 8.0 build 100. Please refer to Directory on EasyBUILD in Driver Required section. 2. After you insert the EasyBUILD 8.0 build 100 into the optical drive, it will be mounted automatically. Please copy the driver from the EasyBUILD 8.0 build 100 to HDD first. # cp /media/EBV71B600/ Disk/R5250/nic/Nvidia/x64/sles10/ nvlan-sles10-0.62-1.23.x86_64.rpm /tmp 3. Install the driver # cd /tmp 95 Altos R5250 Installation Configuration Guide