Brother International PR-1000 Installation Guide for KIT CW PRCW1 - Page 13

ENGLISH INSTALLING THE UPGRADE KIT CW j Carefully verify that the information has been entered correctly and then click "Certify". l Click "Finish". [Step 2] Upgrading the Machine Memo • To change the entered information, click "Back". If an error message appears Check below list for possible error(s). To close the message, click "OK". • Verify that the CD key and internal machine identification number (No.) have been entered correctly, and then repeat the procedure from step c. • The CD Key is valid for use with only one designated internal machine identification number (No.). Check that the CD key has been entered correctly, and then repeat the procedure from step c. • Check the Internet connection, and then click "Certify" again. The machine will be upgraded based on the information obtained in [Step 1]. You can use USB media or a computer to transfer the upgrade file to your embroidery machine. If USB media will be used, refer to the procedure described in [Step 2-1]. If the machine will be connected to the computer, refer to the procedure described in [Step 2-2] (page 10). ■ [Step 2-1] Using USB media a While pressing the automatic needlethreading button, turn the embroidery machine on. b Copy the upgrade program downloaded in step f of "Obtaining the Certification Key" (page 8) to the USB media. k Write down the 8-digit Certification Key that appears. Note • Copy only the upgrade program to a clean re-formatted USB media; no other files should be on this media. Note • After upgrading the embroidery machine to KIT CW, the Certification Key must be entered in the embroidery machine Settings screen. 9