Brother International ULT-2003D Users Manual - English - Page 306

CONTENTS Problem Machine does not operate Embroidery unit does not operate LCD display is difficult to see Nothing happens, even if the LCD display is pressed Cause 1 There is no pattern selected. 2 "Start/Stop" button was not pushed. 3 Main power switch is not turned on. 4 Presser foot is not lowered. 5 "Start/Stop" button was pushed with the foot controller attached. 6 Speed control lever is set to control the zigzag stitch width. 1 There is no pattern selected. 2 Main power switch is not turned on. 3 Embroidery unit is not attached cor- rectly. 4 Embroidery frame was attached before the unit was initialized. 1 LCD contrast is not properly adjusted. 1 The screen has been locked. Solution Select a pattern. Push the "Start/Stop" button. Turn on the main power switch. Lower the presser foot. Remove the foot controller, or use the foot controller to operate the machine. Use the foot controller instead of the "Start/Stop" button to operate the machine. Select a pattern. Turn on the main power switch. Reattach the embroidery unit correctly. Perform the initialization process correctly. Adjust the LCD contrast. Press the screen lock key to unlock the screen. Page 3-9, 4-1 5-8, 6-2 1-4 1-12 1-5 1-7 1-7 5-8, 6-2 1-12 5-5 5-5 1-16, 9-1 2-16 CAUTION • This machine is equipped with a thread detection device. If the "Start/Stop" button is pushed before the upper threading is done, the machine will not operate properly. Also, depending on the pattern selected, the machine may feed the fabric even if the needle is raised. This is due to the needle bar release mechanism. At these times, the machine will make a sound different from that made during normal sewing. This is not the sign of a malfunction. • If the power is disconnected during sewing: - Turn off the main power switch and unplug the machine. - If you restart the machine, follow the instructions for operating the machine correctly. 1 - 2 - 3 - 4 - 5 - 6 - 7 - ?! 8 - 9 - ?! Index Troubleshooting 9-9