Brother International ULT-2003D Users Manual - English - Page 38
thread is not cut with the cutter, and the bobbin, Be sure to follow the process described. If
View all Brother International ULT-2003D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
CONTENTS 1 7. Use both hands to set the thread around projection in the thread guides. 1 - 1 Projection in the thread guides 2 - 1 2 2 8. Pass the thread around the thread guide shaft and the pretension disk as indicated on drawing. Make sure that thread is correctly inserted inside the pretension disk. 1 Thread guide shaft 2 Pretension disk 3 - 4 - 9. Wind the thread clockwise around the bobbin 4-5 times (as shown in the illustration). 5 - 6 - 3 1 7 - 10.Pass the end of the thread through the guide slit in the bobbin winder seat, and pull the thread to the right. The cutter will cut the thread. 8 - 1 Guide slit 2 2 Bobbin winder seat 1 CAUTION 9 - Be sure to follow the process described. If the ?! thread is not cut with the cutter, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break. Index Setting Up 1-27