Cisco G1 Installation Guide - Page 38
Reconnecting AC-Input Power to the Cisco uBR7225VXR Router,
UPC - 746320679488
View all Cisco G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Installing the NPE-G1 or NPE-G2 Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information Reconnecting AC-Input Power to the Cisco uBR7225VXR Router To connect AC-input power to the Cisco uBR7225VXR router, complete the following steps: Step 1 At the rear of the router, ensure that the power switch on the power supply is in the off position. Figure 7-26 Connecting AC-Input Power to a Cisco UBR7225VXR Router 1 uBR7225-VXR 4 uBR7225-VXR 270538 3 2 1 Power switch 2 Handle 4 AC-input receptacle 5 Captive installation screw Step 2 Plug the power cable into the AC connector of the power supply. Note For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie through the hole in the handle and around the cable. Step 3 Step 4 Step 5 Plug the AC power supply cable into the AC power source. Repeat Step 1 through Step 3 for the second power supply, if required. Turn on the power switch on the router. This completes the steps for reconnecting AC-Input power to a Cisco UBR7225VXR router. Proceed to the "Powering Up the Router" section on page 7-45 Reconnecting DC-Input Power to the Cisco 7200 VXR Router To reconnect DC-input power to a Cisco 7200 VXR router, complete the following steps. Note The color coding of the DC-input power supply leads depends on the color coding of the DC power source at your site. Typically, green or green and yellow are used for ground. Make certain that the lead color coding you choose for the DC-input power supply matches the lead color coding used at the DC power source. 7-38 Network Processing Engine and Network Services Engine Installation and Configuration OL-4448-12