Cisco G1 Installation Guide - Page 53

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information Copying the Saved Configuration to NVRAM Copying the Saved Configuration File from a Flash Disk or PC Card To copy the saved configuration file from the Flash Disk or PC Card, follow these steps: Step 1 Step 2 Step 3 Step 4 Make sure you are at the privileged level of the EXEC command interpreter (check the system prompt for a pound sign [#]). If the system prompt does not have a pound sign (#), enter enable, and then your password. Insert the Flash Disk or PC Card containing the saved configuration file into the first PC Card slot in the I/O controller. Enter the copy disk0: filename running or copy slot0: filename running command. Router# copy disk0:filename running or Router# copy slot0:filename running Enter the write command: Router# write You have finished copying and writing the saved configuration file to NVRAM. Copying the Saved Configuration File from the CompactFlash Disk If you have been able to copy the configuration file to the CompactFlash Disk, use the following steps to copy the configuration to the NVRAM on the NPE-G1 or NPE-G2: Step 1 Step 2 Step 3 Step 4 Make sure you are at the privileged level of the EXEC command interpreter (check the system prompt for a pound sign [#]). If the system prompt does not have a pound sign (#), enter enable, and then your password. Insert the CompactFlash Disk containing the saved configuration file into the CompactFlash Disk slot on the NPE-G1 or NPE-G2. Enter the copy disk2: filename command. Router# copy disk2:filename running Enter the write command: Router#: write You have finished copying and writing the saved configuration file to NVRAM. OL-4448-12 Network Processing Engine and Network Services Engine Installation and Configuration 7-53