Dell 3110cn Color Laser Printer User Guide - Page 155

Auto Automatically selects a tray according to the paper size and type settings of the job being printed except for the multipurpose feeder. Used when the communication protocol is in ASCII interface. Standard BCP Used when the communication protocol is in binary format. TBCP* Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Binary Used when no special processing is required. System Settings Use the System Settings menu to configure the basic printer settings. NOTE: Values marked by an asterisk (*) are the factory default menu settings. PowerSaver Time Purpose: To specify the amount of time the printer waits after a job is printed before it goes into the power saver mode. Values: Mode1 5-60 min Specifies the amount of time before the printer enters power saver mode after it finishes a print job. 5 min* Mode2 1-6 min 6 min* Enter 5 to put the printer in power saver mode five minutes after it finishes a print job. This uses much less energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you notice lights flickering. Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm-up time. Select a value between 5 and 60 minutes for power save mode if you