Dell 3110cn Color Laser Printer User Guide - Page 228

Load the recommended print side correctly for the type of print media you are using. See "Loading Print Media in Standard and Optional Trays" for more information. Turn the print media over or around and try printing again to see if feeding improves. Do not mix print media types. Do not mix reams of print media. Remove the top and bottom sheets of a ream before loading the print media. Load a print media source only when it is empty. Wipe the feeder rollers in the trays or multipurpose feeder with a cloth that slightly dampened with water. Envelope misfeeds or multiple Reduce the number of envelopes in the stack. feeds occur. Page breaks in unexpected places. Check the Time-Out in the System Settings menu. Increase the setting. Job prints from the wrong source or on the wrong print media. Check the Paper Type in the Tray Settings menu on the printer operator panel and in the printer driver. Print media does not stack neatly in the output bin. Turn the print media stack over in the tray or multipurpose feeder. Printer does not duplex pages. Make sure 2 Sided is selected in both the PCL (Printer Control Language) menu on the printer operator panel and in the printer driver. Make sure you have enough print memory installed. Print Quality Problems Problem Print is too light. Action · The print cartridges may be low or need to be replaced. Confirm the amount of toner in each print cartridge and replace it with a new one if necessary. · Set the Toner Saving Mode check box to off in the Advanced tab in the printer driver. · If you are printing on an uneven print surface, change the Paper Type settings in the Tray Settings menu. See "System Settings." · Verify that the correct print media is being used.