Dell External OEMR R410 Owners Manual - Page 137
retention hooks., Lift the board out of the system, being careful to avoid damaging
View all Dell External OEMR R410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
6 Disconnect the SAS data cables from the backplane. 7 Remove the SAS backplane from the system: a While pulling the two blue latches towards the front of the system, slide the backplane upward. See Figure 3-27. b When the backplane cannot slide upward any farther, pull the backplane toward the back of the system to remove it from the retention hooks. c Lift the board out of the system, being careful to avoid damaging components on the face of the board. d Place the SAS backplane face down on a work surface. Figure 3-27. Removing and Installing a SAS Backplane 1 2 3 4 5 1 backplane retention latches (2) 3 SAS A cable 5 SAS B cable 2 SAS backplane power cable 4 SAS backplane Installing System Components 137
Installing System Components
137
6
Disconnect the SAS data cables from the backplane.
7
Remove the SAS backplane from the system:
a
While pulling the two blue latches towards the front of the system,
slide the backplane upward. See Figure 3-27.
b
When the backplane cannot slide upward any farther, pull the
backplane toward the back of the system to remove it from the
retention hooks.
c
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
d
Place the SAS backplane face down on a work surface.
Figure 3-27.
Removing and Installing a SAS Backplane
1
backplane retention latches (2)
2
SAS backplane power cable
3
SAS A cable
4
SAS backplane
5
SAS B cable
1
2
3
4
5