Dell External OEMR R410 Owners Manual - Page 96
Installing a Non-Redundant Power Supply, Expansion Cards, Expansion Card Installation Guidelines
View all Dell External OEMR R410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Installing a Non-Redundant Power Supply 1 Open the system. See "Opening the System" on page 82. 2 Place the power supply on the chassis. See Figure 3-10. Tighten the screw to secure the power supply to the chassis. 3 Connect all the power cables to the system board, hard drive(s), and optical drive. 4 Replace the system cover. See "Closing the System" on page 83. 5 Connect the power cable to the power supply and plug the cable into a power outlet. Expansion Cards Expansion Card Installation Guidelines Your system supports one x16 Gen 1 or Gen2 PCIe expansion card installed in connectors on an expansion-card riser. CAUTION: Expansion cards can only be installed in the slots on the expansioncard riser. Do not attempt to install expansion cards directly into the riser connector on the system board. • The expansion slot supports full-height, half-length cards. • The expansion-card slot is not hot-swappable. • PCI Express Generation 1 and Generation 2 expansion cards are supported in the slot. CAUTION: To ensure proper cooling, only one of the two expansion cards can have a power consumption of greater than 15W (up to 25W maximum), not including the integrated storage controller. • Table 3-1 provides a guide for installing expansion cards to ensure proper cooling and mechanical fit. The expansion cards with the highest priority should be installed first using the slot priority indicated. All other expansion cards should be installed in card priority and slot priority order. 96 Installing System Components