Dell External OEMR R410 Owners Manual - Page 92
Power Supplies, Removing a Redundant Power Supply
View all Dell External OEMR R410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Power Supplies Your system supports the following power supply modules: • 480W (non-redundant power supply) • 500W (redundant power supply) If two power supplies are installed, the second power supply provides hotswappable, power redundancy. In redundant mode, the system distributes the power load across both power supplies to maximize efficiency. When a power supply is removed with the system powered on, the full power load is picked up by the remaining power supply. Removing a Redundant Power Supply CAUTION: The system requires one power supply to operate the system normally. On power-redundant systems, remove and replace only one power supply at a time in a system that is powered on. 1 Disconnect the power cable from the power source. 2 Disconnect the power cable from the power supply and remove the Velcro straps that bundle and secure the system cables. NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with power-supply removal. For information about the cable management arm, see the system's rack documentation. 3 Pull the power supply straight out to release it from the power distribution board and clear the chassis. 92 Installing System Components