Dell External OEMR R410 Owners Manual - Page 141
Storage Controller Card on iDRAC6 Express Card Optional
View all Dell External OEMR R410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 82. 3 Remove the system board shroud. See "Removing the System Board Shroud" on page 105. 4 Remove all expansion cards and the integrated storage controller card. See "Removing an Expansion Card" on page 99 and "Removing the Integrated Storage Controller Card" on page 100. 5 Remove the expansion-card riser. See "Removing an Expansion-Card Riser" on page 102. 6 Remove the processor heat sinks. See "Removing a Processor" on page 126. 7 If installed, remove the optional iDRAC6 Enterprise card. See "Removing an iDRAC6 Enterprise Card" on page 111. 8 If installed, remove the optional iDRAC6 Express card. See "Removing an iDRAC6 Express Card (Optional)" on page 108. 9 Disconnect all cables from the system board. 10 Remove the system board assembly: a Remove the nine screws securing the system board to the chassis and then slide the system board assembly toward the front end of the chassis. CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components. b Grasp the system board assembly by the edges of the system board and lift the assembly away from the chassis. See Figure 3-29. Installing System Components 141