Epson EPL-N2000 User Manual - Page 63

LJ4 menu items (continued) Menu item Description Form Sets the number of lines (5 to 128) for the selected paper size and orientation, causing new line spacing settings to be stored in the printer; changes to the Page Size or Orientation settings in SelecType may change the Form setting you select; 60 lines is the default. Source SymSet ** Selects the symbol set number for an optional font ROM source (from 0 to 3199). Dest SymSet ** Selects the symbol set number for an optional font ROM destination (from 0 to 3199). * If the font selected in the FontSource and Font Number settings is not available in the SymSet you choose, the FontSource and Font Number settings return to their default values. ** These menu items are available only when an optional font ROM module is installed. GL2 Menu The GL2 menu controls the settings for the EPSON GL/2 mode, which allows you to use your printer with plotter applications. Within this emulation mode, you can choose between two operational modes: LJ4GL2 and GLlike. For information about GL/2 commands, see Chapter 4 in the Technical Infomation manual. The table below shows the principal differences between these modes. Command Orientation Plotter unit Picture frame LJ4GL2 Printer setting 1/1016 inch Same as LJ4 mode Default positions of P1 and P2 Lower left and right corners, respectively, of picture frame GLlike Landscape only 1/1021 inch Depends on hard-clip limit Inside picture frame Using the Control Panel 3-19